Patch-ID# 110900-11
Keywords: efcode pcicfg.e io atm 155utp card fcode panic 8kb configuring hspci+
Synopsis: SunOS 5.8: /platform/sun4u/kernel/misc/sparcv9/pcicfg.e patch
Date: May/24/2004


Install Requirements: Install in Single User Mode                      
                      Reconfigure immediately after patch is installed                      
                      See Special Install Instructions                      
                      
Solaris Release: 8

SunOS Release: 5.8

Unbundled Product: 

Unbundled Release: 

Xref: 

Topic: SunOS 5.8: /platform/sun4u/kernel/misc/sparcv9/pcicfg.e patch
	*************************************************************************************
	NOTE: This patch may contain one or more OEM-specific platform ports.
	      See the appropriate OEM_NOTES file within the patch for
	      information specific to these platforms.
	      DO NOT INSTALL this patch on an OEM system if a corresponding
	      OEM_NOTES file is not present (or is present, but instructs not
	      to install the patch), unless the OEM vendor directs otherwise.
	**************************************************************************************

Relevant Architectures: sparc.sun4u

BugId's fixed with this patch: 4393561 4393772 4398474 4407705 4422504 4422982 4425717 4456658 4461892 4482012 4496757 4711639 4716448 4717617 4718370 4787898 4792953 4834066 4835953 4879904 4948204

Changes incorporated in this version: 4879904

Patches accumulated and obsoleted by this patch: 113583-01

Patches which conflict with this patch: 

Patches required with this patch: 

Obsoleted by: 

Files included with this patch: 

/platform/sun4u/kernel/misc/sparcv9/pcicfg.e

Problem Description:

4879904 device tree isn't built correctly after a series hotplug commands
 
(from 110900-10)
 
4948204 pcicfg should not reprobe the bars after fcode runs successfully
 
(from 110900-09)
 
4718370 panic when PCI card is configured with hot plug
4792953 physically hotplug a Jasper card result warning when configure
4834066 pcicfg does not pass the prefetch bit to PCI allocator
4835953 ndi_ra_free: bad free messages seen while unconfiguring qlc
 
(from 110900-08)
 
4787898 sci link fails to communicate after hotplug operation
 
(from 110900-07)
 
       This patch revision was generated to accumulate and obsolete the
        feature changes introduced in feature point patch 113583-01.
 
(from 110900-06)
 
4711639 PCI-to-PCI I/O base and limit registers are improperly programmed
4496757 hotplug of cauldron into C5V1 causes panic during configuration
 
(from 110900-05)
 
4717617 pcicfg driver fails to configure the PCI card with PCI Hot Plug
 
(from 110900-04)
 
4716448 problems configuring PCI card with fcode < 8kb
 
(from 110900-03)
 
4407705 ATM 155utp card giving FCODE errors that result in a PANIC
 
(from 110900-02)
 
4422982 A manual configure operation in full hotswap mode can mutex hang in PC hotplug-
4422504 pci hotplug framework needs support for sysevents during full hotswap operations
4425717 panic unconfiguring an IO board while running multiple "cfgadm -a" commands
4456658 panic unconfigure cPCI cards unconfig/config pci buses
4482012 pci hotplug framework must support probing devices under a nontransparent bridge
 
(from 110900-01)
 
4398474 panic during IO Board configure
4393772 efcode bug reports stack underflow error
4393561 myricom copper gbit doesn't work with EFCODE interpreter
 
(from 113583-01)
 
4461892 regression with handling devices with bridges

Patch Installation Instructions:
--------------------------------------------
For Solaris 2.0-2.6 releases, refer to the Install.info file and/or
the README within the patch for instructions on using the generic
'installpatch' and 'backoutpatch' scripts provided with each patch.
 
For Solaris 7-9 releases, refer to the man pages for instructions
on using 'patchadd' and 'patchrm' scripts provided with Solaris.
Any other special or non-generic installation instructions should be
described below as special instructions.  The following example
installs a patch to a standalone machine:
 
       example# patchadd /var/spool/patch/104945-02
 
The following example removes a patch from a standalone system:
 
       example# patchrm 104945-02
 
For additional examples please see the appropriate man pages.

Special Install Instructions:
---------------------------------------
 
Reboot the system after patch installation.
 
	NOTE 1: For complete hsPCI+ support for SF15k (4640542), please
                install the following patches:
 
                108528-18 (or newer)   Kernel Update Patch
                110826-06 (or newer)   schpc patch
                110820-10 (or newer)   dman patch
                109873-15 (or newer)   libprtdiag_psr.so.1 patch
 
	NOTE 2: To get the complete fix for bugids 4718370, 4792953 and 4834066,
                please install the following patch:
 
		110824-04 (or newer)	fcpci driver patch

README -- Last modified date:  Tuesday, September 14, 2004